Data Sheet

Module：825X-LA Series
-
20
-
Waiting for your suggestion at anytime.
E-mail：[e-mail]
2.7 Antennas
Antenna Specification are as follows:
Type: Copper tube Antenna
Gain: 0dBi
This device is intended only for host manufacturers under the following conditions: The
transmitter module may not be co-located with any other transmitter or antenna; The module
shall be only used with the internal antenna(s) that has been originally tested and certified with
this module. The antenna must be either permanently attached or employ a ‘unique’ antenna
coupler.
As long as the conditions above are met, further transmitter test will not be required.
However, the host manufacturer is still responsible for testing their end-product for any
additional compliance requirements required with this module installed (for example, digital
device emissions, PC peripheral requirements, etc.).
2.8 Label and compliance information
Host product manufacturers need to provide a physical or e-label stating “Contains FCC ID:
2AMM6-825X1LA. Contains IC: 26313- 825X1LA.” with their finished product.
2.9 Information on test modes and additional testing requirements
Operation Frequency: 2402~2480MHz
Number of Channel: 40
Modulation: GFSK
Host manufacturer must perfom test of radiated & conducted emission and spurious
emission, etc. according to the actual test modes for a stand-alone modular transmitter in a host,
as well as for multiple simultaneously transmitting modules or other transmitters in a host
product. Only when all the test results of test modes comply with FCC requirements, then the
end product can be sold legally.
2.10 Additional testing
The modular transmitter is only FCC/IC authorized for FCC Part 15 Subpart C 15.247 & 15.207
& 15.209 & RSS GEN&RSS 247 and that the host product manufacturer is responsible for
compliance to any other FCC/IC rules that apply to the host not covered by the modular
transmitter grant of certification. If the grantee markets their product as being Part 15
Subpart B/ICES 003 compliant (when it also contains unintentional-radiator digital circuity),
then the grantee shall provide a notice stating that the final host product still requires Part 15
Subpart B/ ICES 003 compliance testing with the modular transmitter installed.