Specifications

Front
Rear
Smart
Button
55
55
55 X 440 MM 80g 超白哑粉纸 黑白双面印刷 风琴折
Power supply: Battery CR2032 3V DC
Communication: ZigBee 3.0*
Bluetooth Low Energy*
Control distance: 25m open area
Ingress Protection: IP55
Dimensions: 45 X 45 X 12.5mm
Operating temperature: -10 °C~45 °C
Working Humidity: <90%RH
Life of battery: 1 years (General use)
Dimension
1
2. Install the CR2032 battery
Specification
2
Connet to Network
4
3. Hold“RESET”to 6s,
LED will start flashing
Install the battery / Reset / Pairing
3
Add Device
ZigBee model
5
Add Device
Bluetooth model
Remote mode (Default mode)
ZigBee model Only
5.2
1. Remove the screw
CR2032
+
45
12.5
4. Install the cover
Scan the QR code to download APP
Gateway is required to connect device
Hold
6s
ZigBee model Only
Remote mode
5.3
UI or functions may change
according to firmware or
APP version
*Available for selected model
5.1
ZigBee model Only ZigBee model Only
Mode swap
5.5
Scene mode
5.6
Scene mode
5.7
Scene mode
5.8
FCC Warning
5.9
Remote mode
5.4
B. Control description under remote mode
Note: The above functions may be different
depending on the model of the smart bulb
FCC Warning
6
Single Press
On
Single Press
Change preset
light mode
when light up
Dual Press
Off
Long Press >3s
Dimming
3 click
Scene
mode
Remote
mode
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Note: The Grantee is not responsible for any changes or modifications not
expressly approved by the party responsible for
compliance. such modifications could void the user's authority to operate the
equipment.
The device has been evaluated to meet general RF exposure requirement.
To maintain compliance with FCC's RF exposure guidelines, the distance
must be at least 20 cm between the radiator and your body, and fully
supported by the operating and installation configurations of the
transmitter and its antenna(s).
V1.5A