Quick Start Guide
Quick Start Guide
For use with DryCaddy UV
Hold button for 5 seconds
then release.
Red light will flash.
Press and release button once
more. This starts the UV-C
function.
Light will slowly pulse for
approximately 3-1/2 minutes
then shut off automatically.
The UV-C function is complete.
Remove lid / battery cover by
turning counterclockwise.
Re-attach the lid to the drying
unit by aligning tabs on the lid
with notches on the unit. Turn
clockwise to close.
One DryCaddy Disc desiccant and
two AAA batteries are packaged
in the small inner box. Remove the
contents.
Install batteries with correct
polarity.
Remove lid and battery
compartment sections by
turning counterclockwise.
Add hearing devices to the
mirrored surface. Be sure to open
the battery door. You can leave
the batteries inside.
Re-attach the lid to the drying
unit by aligning tabs on the lid
with notches on the unit. Turn
clockwise to close.
MAIN COMPONENTS OF DRYER
Lid / Battery Cover
Battery Compartment with UV-C Lamp
Drying Compartment
Base / Desiccant Compartment
IMPORTANT SAFETY INFORMATION
This product is for household use. When using products
powered by batteries, especially when children are present,
basic safety precautions should always be followed, including:
DANGER–To reduce the risk of electrocution:
• Do not use while bathing.
• Do not place or store product where it can fall or be pulled
into a tub or sink.
• Do not place in or drop into water or other liquid.
• Do not reach for this device if it has fallen into water.
WARNING–To reduce the risk of burns, electrocution, fi re, or
injury to persons:
• NEVER open the drying compartment while the UV light
is on. Looking at the UV light with the naked eye may
cause severe burns to the eye.
• Closely supervise use by, on or near children or invalids.
• Batteries should be kept out of reach of children.
• Use this product only for its intended use as described in this
guide.
• Never operate this product if it is not working properly, if
it has been dropped or damaged, or if the batteries have
corroded. Return it to the place of purchase or service center
for examination and repair.
• Never store batteries in a loose container where they can risk
touching other items.
• Never place the product on a soft surface such as a bed. Keep
any air openings free of lint, hair, and the like.
NOTE: This product is not designed to diagnose, prevent,
monitor, treat, or alleviate disease.
OPERATING CONDITIONS The operating temperature of this
appliance is approximately ambient temperature.
Remove base / desiccant
compartment by turning
counter-clockwise.
Remove foil from DryCaddy Disc
desiccant. Place in desiccant
compartment, holes up. Write
today’s date on the desiccant as a
reminder to replace in one month.
Re-attach the base to the drying
unit by aligning tabs on the base
with notches on the unit. Turn
clockwise to close.
When not in use, your devices should be kept in the
DryCaddy UV appliance with the lid closed. The
desiccant will continue to remove moisture from the
devices.
NOTE: The UV-C lamp may not start immediately if it has not been used for long
periods of time. If the lamp does not turn on, please restart the unit.
1
4
32
What’s included
Installing the Batteries
Activating the UV-C Cycle
Adding Hearing DevicesInstalling the Desiccant
5 SECS
5 SECS
5 SECS
5 SECS
a
a
a
a
c
c
c
c
b
b
b
b
d
d
Ending the Cycle Manually
While the UV-C lamp shuts off
automatically in 3-1/2 minutes,
you may want to stop the cycle
before it is complete. To do so,
simply press and hold the LED
power light for 5 seconds. The
red light will go off indicating the
cycle has stopped.
5 SECS
1-800 -327-1299
|
drycaddyuv.com
Have questions? Need technical support?
Call or email us for assistance.
1-800-327-1299
|
info@dryandstore.com
©ETC DC UV QSG 1020 Rev D