Datasheet

Application guidelines

Arrangement mounting ﬂange for switching- and illumination element, PCB mounting

The arrangement of the mounting anges and their number is

determined by the size of the front panel or PCB. To ensure uni

form, tactile switching, we recommend a layout of the anges as

per adjacent sketch.

60 max.

For large PCBs with several switching elements we recommend

the following procedure:

1. Fit the actuator to the front panel.

2. Clip the mounting ange to the rear of the intended actuator.

3. Screw the PCB with the components soldered to it to the

assembled mounting ange.

This arrangement applies to PCBs 1.6 mm thick.

Front plate

PCB

Spacer

Front plate

PCB

Spacer

Demontage Montageﬂansch

The tool Part No. 92-971.0 must be used for removing the moun-

ting ange from the actuator. Before removing the ange, the PCB

xing screws must be loosened.

If the number of actuators is insufcient, use the spacer Part. No.

92-965.0 which can be attached to the front panel.

The spacer can be adjusted to the following front panel thicknes-

ses: 1.5/2/2.2/3/3.5/4 mm and can be stuck to the back of the

panel free of dirt and grease.

Dismantling mounting ﬂange

07/2019 § eao.com

971