Datasheet

Technical data
Actuator with snap-action switching element
Switching system
The snap-action switching system was designed for switching low
powers in electronic circuits.
Single-break snap-action contact.
Material
Lens
Plastic
Material of contact
Gold contact on nickel plating
Actuator housing
Plastic, colour black
Mechanical characteristics
Terminals
The terminals can be used as soldering terminals.
Max. wire diameter
2 x 0.5 mm²
Max. wire cross-section of stranded cable
1 x 0.75 mm²
Wire cross-section of terminal
1.6 x 0.4 mm²
Tightening torque
For xing nut max. 0.2
Nm
Actuating force
1.4
N
Actuating travel
Approx. 2.2
mm ± 0.2 mm
Mechanical lifetime
Momentary action
2 million cycles of operation
Maintained action
1 million cycles of operation
Electrical characteristics
Illumination
Operating voltage LED:
12 VDC ± 10 %
24 VDC ± 10 %
customer-specic *
)
*
)
The series resistance for LEDs need to be determined and
integrated by customers.
Operating data LED: red 2.0 VDC @ 20mA
yellow 2.1 VDC @ 20mA
green 3.2 VDC @ 20mA
white 3.2 VDC @ 20mA
Electrical life
≥ 500 000 cycles of operation at 30 VDC, 100 mA,
according to IEC 61058-1
Switching voltage and switching current
100 mA at 42 VAC / VDC
Electric strength
500 VAC, 50 Hz, 1 minute between all terminals and earth,
as per IEC 60512-2-11
Ambient conditions
Storage temperature
– 40 °C … + 80 °C
Operating temperature
– 25 °C … + 65 °C
Protection degree
IP40 front side, as per IEC 60529
Shock resistance
(Single impacts, semi-sinusodial)
50 g for 11 ms, as per DIN EN 60068-2-27
Vibration resistance
(sinusoidal)
10 g at 10 – 2000 Hz, amplitude 0.75 mm,
as per IEC 60512-4-4
Approvals
Conformities
2014 / 35 / EC (LVD) for version 230 VAC
2011 / 65 / EC (RoHS)
EAO reserves the right to alter specications without further notice.
eao.com § 06/2019
404
18
01
02
03
04
09
14
17
18
19
22
31
41
45
51
56
57
61
70
71
82
84
92
96