Service manual

80
REV23 4.14.15 TT10-12 4TNV98T
AXLES - GENERAL
(1) Due to engineering change by Dana axles. Your tug may have either a 30 or 35 tooth shaft and joint assembly.
All tugs with continental engines will have 909218-7 (35 tooth). It may be necessary for you to count the teeth on
your shaft and joint assembly to correctly identify the part you require.
POSITION THREAD
WRENCH TORQUE
(LBS.-FT)
Drive Pinion Nut 7/8 - 14 240-300
Differential Bearing Cup Cap Screws 1/2 - 13 70-90
Ring Gear Cap Screws 1/2 - 20 100-120
Cover Screws 3/8 - 16 30-40
Differential Case Cap Screws 7/16 - 14 55-75
Brake Retainer Nuts 1/2 - 20 100-110
Axle Shaft Flange Nuts 7/16 - 20 64-70
Upper Kingpin 1 1/8 - 12 500-600
Kingpin Cap Cap Screws 1/2 - 20 70-90
Spindle Mounting Nuts 1/2 - 20 60-80
Tie Rod Stud Nut 5/8 - 18 70 Min (2)
Tie Rod Clamp Nuts 1/2 - 20 35-45
Steering Arm Nuts 1/2 - 20 70-90
Steering Arm Stop Screw & Jam Nut 1/2 - 20 10-20
RECOMMENDED TORQUE SPECIFICATIONS DANA 70 AXLE
(2) Note—If cotter pin cannot be installed after minimum torque is attained, the nut must be advanced until cot-
ter pin can be installed.
(3) When replacing steering knuckles be sure that upon installation your steering cylinders (see pages 48-51) must
be adjusted so when in full turn to the right and then full turn to the left the cylinder does not pull steering arm
more than 3/16 of an inch. If you have any questions please call Eagle Tugs technical department.