SDS

MATERIAL SAFETY DATA SHEET

Complies with OSHA’s Hazard Communication Standard, 29 CFR 1910.1200

REVSION: 7/10/07

SECTION I-MANUFACTURER

NAME: Eagle IFP 24 Hour Emergency Telephone No.

P.O. Box 100431 INFOTRAC

Nashville, TN 37224 1-800-535-5035

Tel: 615-872-2710

SECTION II-PRODUCT IDENTIFICATION

IDENTITY: Eagle Supreme Seal Low VOC

HMIS CODES: H F R P

2 4 0 G

SECTION III-COMPONENTS

CAS # OSHA PEL(TWA) ACGIH(TLV-TWA)

Acrylic Polymer Proprietary None Established None Established

Aromatic Naphtha* 64742-95-6 *see below *see below

Toluene 108-88-3 200 ppm 50 ppm

Acetone 67-64-1 1000 ppm 500 ppm

Mineral Spirits 8052-41-3 100 ppm 100 ppm

*Aromatic Naphtha and Mineral Spirits contain the following:

CAS# OSHA PEL(TWA) ACGIH(TLV-TWA) Wt.% of coating

Cumene 98-82-8 50 ppm 50 ppm <0.70%

1,2,4 Trimethylbenzene 95-63-6 25 ppm(1989 std.) 25 ppm 10.9-14.4%

1,3,5 Trimethylbenzene 108-67-8 25 ppm(1989 std.) 25 ppm 3.8-4.9%

Xylene isomers 1330-20-7 100 ppm 100 ppm 0.4-1.4%

SECTION IV-PHYSICAL/CHEMICAL CHARACTERISTICS

Specific Gravity (H20=1): 0.82 Flash Point(TCC): 0° F

Vapor Density (Air=1): 4.3 Odor: Acetone and aromatic hydrocarbon

Material V.O.C.: <350 g/l Appearance: Clear liquid

SECTION V-FIRE AND EXPLOSION HAZARD DATA

Flash Point (TCC): 0° F

Flammable Limits(% volume in air): LEL=1.1 UEL=12.8

Extinguishing Media: Dry chemical, CO2, alcohol-resistant foam

Special Fire Fighting Procedures: Evacuate area and fight fire from a distance. Firefighters wear NIOSH

approved self-contained breathing apparatus. Cool containers exposed to fire with water. Vapors are heavier than

air and may travel along the ground to distant ignition sources.

PAGE 1
MATERIAL SAFETY DATA SHEET Complies with OSHA’s Hazard Communication Standard, 29 CFR 1910.1200 REVSION: 7/10/07 SECTION I-MANUFACTURER NAME: Eagle IFP P.O. Box 100431 Nashville, TN 37224 Tel: 615-872-2710 24 Hour Emergency Telephone No.
PAGE 2
SECTION VI-REACTIVITY DATA Reactivity: Stable Conditions to avoid: Prevent vapor accumulation. Avoid heat and flames. Incompatibility (Materials to Avoid): Strong oxidizers. Hazardous Decomposition (Byproducts): Carbon monoxide and carbon dioxide. Hazardous Polymerization: Should not occur. SECTION VII-HAZARDS IDENTIFICATION Routes of Exposure: Inhalation, Ingestion, eyes, and Skin. Health Hazards: Acute: May cause eye, skin, gastrointestinal, and lung irritation.
PAGE 3
SECTION X-PRECAUTIONS FOR SAFE HANDLING AND USE Normal Handling: Always use good industrial hygiene practices and safety guidelines. Storage: Store material in its original container. Keep containers tightly closed when not in use. Keep material away from open flame, sparks, or other sources of heat and ignition. Waste Disposal Method: Liquid material is an ignitable waste (D001). Dispose of material in accordance with federal, state, and local guidelines.