Storage [ET-CSESU2-BK] Eagle | Consus E-Series SATA to USB2.0 External Storage System User Manual www.eagle-techusa.
Understand Eagle Tech Brand Product Categories Eagle Tech sub-brand Power Supply Power External Storage Storage Media Center Media PC Chassis case Industrial Power Rackmount Power Supply Rackmount Industrial PC
CONTENTS Ɣ 3$&.$*( &217(176 Ɣ )($785(6 3.Under the [Disk Utilities], choose the new hard drive (1) and click [Partition] (2). Click [Options] to choose format other than [Mac Extended] (3) refer to [Figure 1] at page 16. Choose the number of partition you want by clicking on the scroll bar (4). Name the new hard drive (5). Choose the [Format] (6) refer to [Figure 2] at page 16.
PACKAGE CONTENTS 9.When the status change to Healthy, your new Hard Drive is ready to use. Ɣ ´ 86% ([WHUQDO (QFORVXUH Ɣ $ PDOH WR % PDOH 86% FDEOH Ɣ $& '& 9 9 VZLWFKLQJ power adapter 10.Go to My Computer, your new drive should be listed there and ready to use. Ɣ 3RZHU FRUG Mac OS X Ɣ 9HUWLFDO VWDQG Note: If the warning does not show up, start at step 2. 1.A warning window will pop up for new and unformatted hard drive. Click [Initialize]. Skip Step 2 and continue at Step 3.
FEATURES Ɣ Aluminum case and special radiator design extend working life of the hard disk Ɣ Support all the 3.5” HDD up to 500G Ɣ Convert 3.5” HDD become to USB 2.0 port Ɣ Attractive blue LED indicates for power Ɣ Transfer rate up to 480Mbps/USB 2.0 (12Mbps/USB 1.1) and Plug & Play and Hot-swappable 7.Confirm your setting and click [Finish]. 8.It would show the status as Formatting. SPECIFICATION Ɣ 3.5” External HDD enclosure Ɣ 2.
SYSTEM REQUIREMENT 4.On the next page, choose your partition size then click [Next]. PC Requirements: Minimum Intel Processor 350M Hz, 64MB RAM USB 2.0/1.1: Windows ME/2000/XP Computer must have proper port or USB card Mac Requirements: Minimum Apple G3 processor, 64 MB RAM USB 2.0 equipped Mac; Mac OS 10.2, 10.3 USB 1.1 equipped Mac; Mac OS 9.1, 9.2, 10.1.5, 10.2, 10. Computer must have proper port or USB card DISK INSTALLATION 5.
2.Draw out the both side bar 3.After New Partition Wizard launched, then click [Next]. 3.
4. Tighten up the screws to fix the HDD and put back the both side bar. PARTITION HARD DISK Windows XP/2000/2003 Note: For formatted Hard Drive, proceed to step 2. 1.Click the [start] button and click on [Control Panel], double-click the [Administrative Tools], and then double-click the [Computer Management]. 5. Connect the SATA data transfer and power cable to HDD. 2.Click the [Disk Management] under [Storage]. Your new Hard Drive should have the right capacity shown. (E.g.
6. Put back the rear panel and tighten up the screw. HARDWARE CONNECTION 3.Once Windows prompts [You may safely remove this device], you can then unplug the USB cable from the USB port of computer. Mac OS When disconnecting the external enclosure form computer, close all windows and quit all running applications that are stored on the external drive and drag the [External Drive] icon into [Trash] to dismount it from the desktop prior to unplugging the external enclosure from the connection port. 10 1.
DRIVERS INSTALLATION Windows ME, 2000, XP and above versions Under the above mentioned system, you don’t have to install additional device drivers. The system will detect a USB Mass Storage Device automatically whenever you plugging the USB external enclosure into your computer. 1.Once you plugging the USB external enclosure, system will assign a drive letter to the device and will usually designate it as [USB DISK]. 2.
