Specification

Safety Data Sheet
Eagle Solid Color Sealer Stain (all colors) Rev. Date 5/13/15 Page 3 of 5
from open flame, sparks, or other sources of heat and ignition.
Waste Disposal Method: Liquid material is an ignitable waste (D001). Dispose of material in accordance with
federal, state, and local guidelines.
Special Precautions: Use proper bonding/grounding techniques to avoid static buildup/discharge, which can ignite
vapors. Empty containers may contain explosive levels of vapor. Do not cut, drill, or weld on or near the containers.
Section 8 Protection Information
Respiratory Protection: Use NIOSH-approved organic vapor respirator when exposure levels can’t be kept below
limits.
Ventilation: Provide adequate mechanical ventilation to keep exposure levels below TLV’s.
Protective Gloves: Wear impervious chemical gloves.
Eye Protection: Wear chemical safety glasses.
Other Protective Clothing or Equipment: As needed to prevent repeated/prolonged contact.
Work/Hygienic Practices: Use only in adequately-ventilated area unless recommended respiratory protection is
used. Wash thoroughly with soap and water after handling and before eating, smoking, or using washroom. If
clothes become contaminated, change to clean clothing and wash contaminated clothes before re-use.
Section 9 Physical Data
Appearance: Opaque colored liquid
Odor: Aromatic
Odor Threshold: No data available
pH: None
Freezing/Melting Point: -63° F
Boiling Point: 300° F
Flash Point: 105° F
Evaporation Rate: 0.9 (butyl acetate = 1)
Flammability (solid, gas): No data available
Lower/Upper Flammability: 1.0 – 7.0
Vapor Pressure: 2.1 mm Hg at 20° C
Vapor Density: 3.5 (air=1)
Density: 1.11 g/cc
Solubility: Negligible
Partition Coefficient: No data available
Auto-ignition Temperature: 865° F
Decomposition temperature: No data available
Viscosity: 20 - 30 centipoise
Section 10 Reactivity Data
Reactivity: Stable
Conditions to avoid: Prevent vapor accumulation. Avoid heat and flames.
Incompatibility (Materials to Avoid): Strong oxidizers, acids, alkalies, nitrates.
Hazardous Decomposition (Byproducts): Carbon monoxide and carbon dioxide.
Hazardous Polymerization: Should not occur.
Section 11 Toxicity Data
Routes of Exposure: Inhalation, Ingestion, eyes, and Skin.
Acute Toxicity Lethal Doses (ATE):
LC50 (inhl) 8.7 mg/l
LD50 (oral) 7564 mg/kg
LD50 (skin) 7880 mg/kg
Health Hazards:
Acute: May cause eye, skin, and lung irritation. May cause central nervous system depression, causing
drowsiness and dizziness.
Chronic: Prolonged and repeated exposures to high concentrations may cause damage to central nervous
system, liver, kidneys.
Skin Contact: May cause irritation and redness. Prolonged or repeated exposure can cause defatting and drying of
the skin which may result in a burning sensation and a dried, cracked appearance.
Eye Contact: Causes redness, tearing, irritation of the eyes. Direct contact will cause serious eye irritation.
Inhalation: May cause headache, nausea, dizziness, and loss of coordination. Continued inhalation may result in
unconsciousnes.
Ingestion: May cause gastrointestinal irritation. Aspiration of the material into the lungs can cause chemical