Specification

Safety Data Sheet
Eagle Solid Color Sealer Stain (all colors) Rev. Date 5/13/15 Page 2 of 5
P304+P340+P312 IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for
breathing. Call a poison center or doctor/physician if you feel unwell.
P305+p351+p338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if
present and easy to do. Continue rinsing.
P333+P313 If skin irritation or rash occurs, get medical advice/attention
P370+P378 In case of fire: Use dry sand, dry chemical, or alcohol-resistant foam for extinction
Storage:
P403+P233+P235 Store in a well-ventilated place. Keep container tightly closed. Keep cool.
Disposal:
P501 Dispose of contents/container in accordance with local/federal regulations.
Section 3 Composition/ Information on Ingredients
CAS # OSHA PEL(TWA) ACGIH(TLV-TWA) Conc.(wt. %)
Acrylic Polymer 028262-63-7 Not established Not established 20.0
Solvent Naphtha, Light 64742-95-6 Not established Not established 51.0
Titanium Dioxide 13463-67-7 Not established Not established 10.0
Red Oxide pigment 1309-37-1 Not established Not established 10.0
Yellow Oxide pigment 51274-00-1 Not established Not established 10.0
Carbon Black pigment 1333-86-4 Not established Not established 10.0
Burnt Umber pigment 12713-03-0 Not established Not established 10.0
bis(2-Ethylhexyl) phthalate 117-81-7 5 ppm 5 ppm 0.5
Solvent Naphtha, Heavy 64742-94-5 17 ppm 5 mg/m
3
4.6
Benzene, trimethyl 25551-13-7 25 ppm 25 ppm 30.5
1,2,4-Trimethylbenzene 95-63-6 25 ppm(1989 std.) 25 ppm 20.5
Cumene 98-82-8 50 ppm 50 ppm 5.1
Naphthalene 91-20-3 10 ppm 10 ppm 0.2
Mixed xylene isomers 1330-20-7 100 ppm 100 ppm 3.5
Toluene 108-88-3 200 ppm 50 ppm 0.6
Cymenes 25155-15-1 Not established Not established 0.8
Section 4 First Aid Measures
Emergency First Aid Procedures
Skin: Clean material from skin with acetone, then wash with soap and water followed by moisturizer. If irritation
persists, contact a physician.
Eyes: Flush with a gentle but large stream of clean water for 15 minutes, lifting the lower and upper eyelids
occasionally. Remove contact lenses if able. Call a physician if irritation persists.
Inhalation: Move to fresh air and provide oxygen if breathing is difficult. Seek medical attention.
Ingestion: DO NOT INDUCE VOMITING. Give large quantities of water. Do not give milk or alcoholic beverages. If
vomiting occurs spontaneously, keep head below hips to prevent aspiration of liquid into the lungs. Get medical
attention immediately.
Section 5 Firefighting Procedures
Suitable Extinguishing Media: Dry chemical, CO2, alcohol-resistant foam
Unsuitable Extinguishing Media: High-volume water jet
Flash Point (TCC): 105° F
Flammable Limits (% volume in air for solvents): LEL=1.0 UEL=7.0
Special Fire Fighting Procedures: Evacuate area and fight fire from a distance. Firefighters wear NIOSH approved
self-contained breathing apparatus. Cool containers exposed to fire with water. Vapors are heavier than air and may
travel along the ground to distant ignition sources. Do not allow runoff from firefighting to enter drains or water
courses.
Section 6 Spill or Leak Procedures
Steps to Take if Material is Released or Spilled: No health affects expected from the clean-up of the material if
contact can be avoided. Follow the protection information found in Section 8 of this SDS. Ventilate the contaminated
area. Prevent the spread of spilled material by using a suitable absorbent material or sand dam.
Section 7 Handling and Storage
Normal Handling: Always use good industrial hygiene practices and safety guidelines.
Storage: Store material in its original container. Keep containers tightly closed when not in use. Keep material away