Product Manual

Wear hearing protection.

Wear eye protection.

Wear respiratory protection.

Read the instruction manual

Air and uid volume controls: These two controls

are used in conjunction with each other to accurately

adjust air/uid (Paint) ratio and will vary for different

paints. Changing one control affects the other so

alternating back and forth between them to ne tune

your adjustment will yield optimum results

Air volume control: Air volume is adjusted by turning

the air knob control. Turning knob in reduces volume,

turning knob out increases volume.

Fluid volume control: Fluid volume is adjusted by

turning the uid volume control knob. Turning knob

in decreases volume, turning knob out increases vol-

ume. Once a satisfactory volume is set, you can lock

the adjustment by turning the lock nut in tight.

Air Volume control

Fluid Volume control

MAINTENANCE

Clean gun before and after each use. To protect the precision machined internal parts

and ttings in this gun from corrosion during shipping, some oils or other corrosion resistant

agents may have been applied. It is important to remove any such residue before attempt-

ing to use the gun. To clean, place a small amount of appropriate thinner into paint cup

and spray through gun while pulling and releasing trigger repeatedly. Wipe exterior of gun,

nozzles and paint cup. In some cases if the gun becomes clogged, disassemble completely

and soak all parts in thinner. After soaking, use a thin cleaning brush to clear small internal

passages. Check and clean paint cup lter, when installed. Replace if worn.

A clean air source is imperative to ensure peak performance. The use of an in-line air lter

is highly recommended to keep any contaminants from entering the spray gun.

In some painting applications proper air drying and ltration equipment may be required.

Inspect all ttings and hardware to ensure proper seating. Be sure air line ttings are tight

with no leaks. Replace any worn parts as necessary.

Check needle and nozzles for nicks, scratches or burrs. Any such conditions will seriously

impair performance. Replace as necessary.

OPERATION