Specification

Safety Data Sheet
Eagle Crack Filler (all colors) Rev. 3/4/15 Page 2 of 3
containers exposed to fire with water.
Section 6 Spill or Leak Procedures
Steps to Take if Material is Released or Spilled: No health affects expected from the clean-up of the material if
contact can be avoided. Follow the protection information found in Section 8 of this SDS. Absorb spillage in suitable
inert material. Sweep or scrape up and containerize. Rinse affected area thoroughly with water.
Section 7 Handling and Storage
Normal Handling: Always use good industrial hygiene practices and safety guidelines.
Storage: Store material in its original container. Keep containers tightly closed when not in use.
Waste Disposal Method: Material is not considered a RCRA Hazardous Waste. Dispose of material in accordance
with federal, state, and local guidelines.
Special Precautions: Avoid freezing. Store in a cool, dry place with adequate ventilation.
Section 8 Protection Information
Respiratory Protection: Use NIOSH-approved particulate respirator if grinding/sanding cured material and exposure
levels cannot be maintained below limits or the chance of dust inhalation is present.
Ventilation: Provide adequate mechanical ventilatio.
Protective Gloves: Wear impervious chemical gloves.
Eye Protection: Wear chemical safety glasses.
Other Protective Clothing or Equipment: As needed to prevent repeated/prolonged contact.
Work/Hygienic Practices: Use only in adequately-ventilated area unless recommended respiratory protection is
used. Wash thoroughly with soap and water after handling and before eating, smoking, or using washroom. If
clothes become contaminated, change to clean clothing and wash contaminated clothes before re-use.
Section 9 Physical Data
Appearance: Milky brown/white/gray liquid
Odor: Sweet
Odor Threshold: No data available
pH: 8.5-9.5
Freezing/Melting Point: Not determined
Boiling Point: 212° F
Flash Point: N/A
Evaporation Rate: Not determined
Flammability (solid, gas): Non-flammable liquid
Upper/lower Flammability: Not determined
Vapor Pressure: 2.3 kPa (@ 20°C)
Vapor Density: 0.62 (air=1)
Relative Density: 1.82 g/cc
Solubility: Miscible with water
Partition Coefficient: Not determined
Auto-ignition Temperature: Not determined
Decomposition temperature: Not determined
Viscosity: Not determined
Section 10 Reactivity Data
Reactivity: Stable.
Conditions to avoid: None known.
Hazardous decomposition products: Produces normal products of combustion
Hazardous Polymerization: Will not occur.
Section 11 Toxicity Data
Carcinogen: This product contains silica sand. When the product is in liquid form during application, there is no risk
of inhalation. However, if the cured product is ground or sanded it may create hazardous silica dust, which is an IARC
Group 1 known human carcinogen.
Routes of Exposure: Inhalation, ingestion, eyes, and skin.
Acute Toxicity Lethal Doses (ATE):
LC50 (inhl) 583 mg/l
LD50 (oral) >20,000 mg/kg
LD50 (skin) >20,000 mg/kg