Installation Guide

CRACK FILLER
USES
Cosmetically fills cracks in the following concrete surfaces:
 BROWN on Exposed Pea Gravel Concrete
 GRAY on Exposed Gray Chipped Limestone Concrete
 WHITE (Light Gray) on Broomed Swept Concrete
DESCRIPTION
EAGLE CRACK FILLER cosmetically repairs scars, gouges and cracks in outdoor
concrete surfaces. This crack filler will match the texture, color and appearance of specified
concrete surfaces. Using this product and appropriate EAGLE CONCRETE SEALER makes
the crack virtually disappear. EAGLE CRACK FILLER must be sealed for maximum blending
and longevity. For a more structural repair, fill crack with epoxy or exterior caulk before
topping with EAGLE CRACK FILLER. 1 quart will fill approximately 100 ft. of normal cracks.
APPLICATION
1. Clean concrete well with a power washer.
2. SHAKE WELL!
3. Remove cap and snip spout to desired width of pour.
4. Pour EAGLE CRACK FILLER into crack. Concrete can be damp but crack should be
sufficiently dry so there is no standing water in the crack.
5. Allow EAGLE CRACK FILLER to dry for 4 hours before sealing.
6. Seal with appropriate EAGLE CONCRETE SEALER for your surface.
PRECAUTION
Protect from freezing. Apply when air and surface temperature is above 50° F and
below 90° F. Do not apply when rain is expected within 4 hours. Discard after use. Opened
bottle will not store well.
TECHNICAL DATA HMIS
VOC: 0 g/L Health 0 Flammability 0
Flash Point: N/A Reactivity 0 Protection 0
DISCLAIMER: Since manufacturer has no control over handling, use or storage; no guarantee expressed or implied, is offered. Eagle IFP warrants the product to be free of defects and will replace or
refund the purchase price of said products proven defective. Labor cost and/or other consequential damages are not covered by this warranty. Responsibility for claims of any kind is strictly limited to
the purchase price of the product. The suitability of the product for any extended use shall be solely up to the user.
Made in U.S.A
EAGLE IFP COMPANY
www.eaglesealer.com