Installation Guide

SATIN SEAL
TOOLS & MATERIALS REQUIRED
 EAGLE CLEANER DEGREASER & NEUTRALIZER
 EAGLE ETCH & CLEAN
 Pump-up sprayer
 Medium/short nap roller, lamb’s wool or microfiber applicator (dependent upon surface)
USES
EAGLE SATIN SEAL is a water-based acrylic sealer formulated especially for broom swept concrete
that dries to a satin sheen without excess darkening of concrete. EAGLE SATIN SEAL resists oils, detergents,
acids, salts, and most chemicals. When applied properly, it resists cracking, peeling, mildew, staining, and
erosion of concrete. EAGLE SATIN SEAL can also be used as a paver sealer, applied with a low pressure
garden sprayer.
SURFACE PREPARATION
Clean dirt, wax, grease, oil and other contaminants from the surface. Be sure to remove any foreign
coating unless previous coating is same or similar water-based sealer. Make sure the surface is clean, dry
and sound. Clean oily concrete with EAGLE CLEANER DEGREASER & NEUTRALIZER. Use a bristle brush
for heavily oiled spots. If surface is slick, etch with EAGLE ETCH & CLEAN. Rinse well with a pressure
washer. Allow 24 hours to dry. Concrete must be porous enough to accept water. Dense concrete surfaces
may require mechanical preparation to accept sealer. Apply only when surface and air temperatures are
above 50° F and below 90° F. Do not apply to excessively hot surfaces as rapid drying may cause bubbles or
streaking to form. For pavers, sweep away any loose sand.
APPLICATION
Perform test to ensure compatibility. Apply at substrate temperatures above 50° F and below 90° F.
Apply with sprayer. On exterior concrete, you may use a medium nap roller. For smooth concrete you may
use a lamb’s wool or microfiber applicator or short nap roller and cross roll. Thoroughly saturate surface.
Apply additional coats as needed for increased gloss. Allow 4 hours for foot traffic, 72 hours for auto traffic.
Do not apply if rain is imminent.
NET COVERAGE RATE
Two thin coats are recommended.
Smooth Troweled: 300 ft² per gallon Textured or Stamped: 200 ft² per gallon
Broom Swept: 200 ft² per gallon Pavers: 100 ft² per gallon
CLEANUP
Clean tools with water
MAINTENANCE
Clean sealed surface with water only. Reseal surface every two years or as needed to prevent buildup
of sealer.
TECHNICAL DATA HMIS
VOC: <63g/L Health 1 Flammability 0
Flash Point: N/A Reactivity 0 Protection B
DISCLAIMER: Since manufacturer has no control over handling, use or storage; no guarantee expressed or implied, is offered. Eagle IFP warrants the product to be free of defects and will replace
or refund the purchase price of said products proven defective. Labor cost and/or other consequential damages are not covered by this warranty. Responsibility for claims of any kind is strictly limited to
the purchase price of the product. The suitability of the product for any extended use shall be solely up to the user.
Made in U.S.A
EAGLE IFP COMPANY
www.eaglesealer.com