Instruction manual

4- & 8-Channel Digital Video Recorder
67
Once you set your desired search conditions, highlight Search and press the button to display
the search results in the Event Log Search screen. Selecting Cancel exits the screen without
saving the changes.
Record Table Search
There are three view modes. Standard view, Expanded view and Compact view. Standard view
(default) displays combined recording information of all camera channels currently displayed on
the screen. In the Standard view mode, selecting the
icon located at the bottom switches to the
Expanded view mode. The Expanded view displays the recording information of each camera
channel currently displayed on the screen. Selecting the
icon in the Standard view mode
switches to the Compact view mode which displays only the toolbar. Selecting the
icon in the
Compact view mode switches to the Standard view mode, and selecting the
icon in the Expanded
view mode switches to the Standard view mode.
Selecting
or
located at the bottom zooms the record table. Selecting
displays eight hours
(1-minute based), and selecting
displays 24 hours (3-minute based) at once. To move to earlier
or later times that are not shown in the current record table screen, select the arrows located at the
end of the times by using the arrow buttons on the front panel.
NOTE: If the DVR has images recorded in more than one recording mode in the same time
range, the recording status bar displays recording information in the following priority order:
Panic
Æ
Pre-Event
Æ
Event
Æ
Time. The color of the bar indicates different recording
modes: Red for Panic, Yellow for Pre-Event, Purple for Event, and Blue for Time.
Selecting
located at the bottom displays the Calendar Search screen.
< Compact View >
< Standard View >
< Expanded View >
Figure 66  Record Table Search screen.
Recording information about video images
currently displayed on the screen displays on the
recording status bar. A grey vertical line indicates
the current search position. To search specific
video, move the vertical line by using the Left
or Right arrow buttons on the front panel or by
clicking the mouse on the desired segment.
If the DVR’s time and date have been reset to a
time that is earlier than some recorded video, it
is possible for the DVR to have more than one
video stream in the same time range. In this case,
the overlapping time range in the record table will
be separated by a yellow vertical line.
NOTE: The recorded data in the time range
located after the yellow vertical line is the
latest.