Instruction manual

User’s Manual
36
NOTE: Sequence cannot be used in the 3x3 and 1+7 modes of the 8-channel DVR, and 2x2
mode of the 4-channel DVR.
You can adjust the display dwell time by highlighting the box beside Interval and pressing the
button. You can select dwell intervals ranging from 1 second to 1 minute.
Highlight Event Monitoring On and press the button. Pressing the button toggles between
On and Off. When it is On, the DVR will display the camera associated with the event when an
event occurs.
Highlight the VGA tab, and the VGA setup screen appears.
Remote Control
Highlight Remote Control in the Devices menu and press the button. The Remote Control
setup screen allows you to select a port and make correct settings for a remote keyboard.
Figure 36  VGA setup screen.
Highlight the box beside Resolution and press
the
button. You can select from 800x600,
1024x768 and 1280x1024.
Highlight the box Test box and press the
button to test how the screen will be displayed
with the resolution you set.
Highlighting OK and pressing the button applies resolution changes.
Figure 37  Remote Control setup screen.
Highlight the box beside Port and select
between None, RS232 and RS485. If the RS232
port and RS485 port is in use for PTZ control,
networking or text input, the remote keyboard
cannot be configured.
Highlight Setup… and select the correct Baud
Rate, Parity, Data Bits and Stop Bits for the
device you are connecting to the DVR.
Highlight the box beside Remote Control
Product and select the device from the list.