Instruction manual

4- & 8-Channel Digital Video Recorder

Highlight the RTSP tab, and the RTSP setup screen displays.

Figure 24  RTSP setup screen.

Highlight Enable RTSP (Real-Time

Streaming Protocol) and press the

button to

toggle between On and Off. You will be able

to change the settings if Enable RTSP is

enabled.

NOTE: When selecting Enable RTSP, the

recorded image resolution cannot be set to

Very High during Record setup.

Highlight the box beside RTSP Port and press

the

button. Set the port number of the RTSP

server obtained from your system administrator.

Highlight the box beside RTP Start Port and press the button. Set the start port number of

the RTP server obtained from your system administrator.

Highlight the box beside RTP End Port and press the button. Set the end port number of the

RTP server obtained from your system administrator.

Highlight Use Mobile and press the button to toggle between On and Off. When set to on, you

can access a remote DVR using a Blackberry or other mobile devices.

NOTE: Selecting Use Mobile sets the recorded image resolution to Standard automatically

regardless of your Record settings.

NOTE: Selecting Use Mobile sets the remote watch quality to Basic automatically regardless

of your Network – Remote Watch settings.

NOTE: Selecting Use Mobile sets the WebGuard service to be enabled automatically

regardless of your WebGuard settings.

NOTE: You can access a remote DVR and monitor live video images using media players,

such as VLC Player, supporting RTSP service. Start the media player on your local PC and

enter “rtsp://ID:Password@IP address:RTSP port number/track ID=‘channel number’”, or

start Internet Explorer on your Blackberry or other mobile devices and enter “http://IP address:

Webguard port number/”.

NOTE: When accessing a remote DVR using mobile devices, live monitoring might be

interrupted on some media players because of network conditions.

NOTE: RTSP service might not be supported, depending on the type of media player.

Highlight the WebGuard tab, and the WebGuard setup screen displays.