Instruction manual

User’s Manual

NOTE: Entering the ID and Password and highlighting OK reads the current IP address of

the DVR configured by the ADSL network.

NOTE: If the DVR is configured for DHCP or an ADSL network, the IP address of the DVR

might change whenever the unit is turned on.

Highlight the DVRNS tab, and the DVRNS setup screen displays.

NOTE: You will need to get the IP Address or domain name of the DVRNS Server from your

network administrator.

NOTE: You can use the domain name instead of IP address if you already set up the DNS

Server when setting up the LAN.

Highlight the box beside Port and press the button. Set the port number of the DVRNS server

using the Up and Down arrow buttons to increase or decrease the numbers.

Highlight Enable NAT and press the button to toggle between On and Off.

NOTE: When using the NAT (Network Address Translation) device, refer to the NAT

manufacturer’ instructions for the proper network settings.

Highlight the box beside DVR Name and press the button. A virtual keyboard appears allowing

you to enter the DVR name to be registered on the DVRNS server.

Highlight the Check box and press the button to check whether or not the name you entered

can be used.

NOTE: The DVR name you entered should be checked by selecting Check, otherwise the

DVRNS changes will not be saved.

NOTE: When entering no name or a name already registered on the DVRNS server, an error

message displays.

Highlighting Save and pressing the button registers the DVR on the DVRNS server. Proper

DVRNS settings will display the help desk information of the DVRNS server in the box beside

Help Desk.

Figure 23  DVRNS setup screen.

Highlight Enable DVR Name Service and

press the

button to toggle between On and Off.

NOTE: The DVRNS (DVR Name Service)

allows the DVR to use Dynamic IP addresses

for remote connection. When this feature is

On, you can access your DVR remotely using

the DVR name instead of its IP address.

For the DVRNS feature, the DVR should be

registered on the DVRNS server.

Highlight the box beside DVRNS Server and

press the

button. A virtual keyboard appears

allowing you to enter the IP address or domain

name of the DVRNS server.