Instruction manual

4- & 8-Channel Digital Video Recorder

NOTE: For the UPnP service to work, the NAT device should support the UPnP Port

Forwarding function and the function should be set to enabled.

NOTE: You cannot change the port settings when Use UPnP is On.

Highlight the Status box and press the button to display the port numbers forwarded from the

NAT device via UPnP service.

Highlight the Port Number Setup… box and press the button. The Port Number Setup

screen appears.

NOTE: You will need to get the appropriate Port Numbers for each RAS and WebGuard

related program (Admin, Callback, Watch, Search and Audio) from your network

administrator.

NOTE: Do NOT use the same port number for two different programs, otherwise, the DVR

cannot be connected with the PC running RAS or WebGuard.

CAUTION: When changing the port settings, you must change the port settings on the

PC running RAS as well. Refer to the RAS manual for details.

Change the numbers by highlighting them and using the Up and

Down arrow buttons to increase or decrease the number. The

factory default Port settings are:

Remote Admin: 8200 Remote Callback: 8201

Remote Watch: 8016 Remote Search: 10019

Remote Audio: 8116

Selecting DHCP from the Type and highlighting

Save button reads the current IP address of the

DVR configured by DHCP (Dynamic Host

Configuration Protocol) network.

Highlight Auto (Default) and press the

button to toggle between On and Off. When

it is On, the DVR will obtain the IP address

of the DNS server automatically.

NOTE: Selecting Auto will only be enabled

when the DVR is configured for DHCP or an

ADSL network.

Selecting ADSL (with PPPoE) allows you to

set up the ADSL network.

Highlight the box beside ID and press the

button. A virtual keyboard appears allowing

you to enter the ID for ADSL connection.

Highlight the box beside Password and press

the

button. A virtual keyboard appears

allowing you to enter the password for ADSL

connection.