Specifications

Here is a table showing the types of cameras and lens configurations supported by the PT-101 :
NOTE: All Hitachi cameras used with the PT-101 head must be set to Hitachi RC-Z3
communications mode if remote camera control is desired via the optional PT-CCB-101
chipset!! The baud rate of the camera must be set to 9600. Consult your Hitachi camera
operation manual for details on how to do this.
If your camera / lens combination does not appear in this table, contact Eagle™ tech support for
configuration help.
Next, build up and attach the 5 pin main power and data connector to the bottom of the PT-101
head.
NOTE: It is very important to build and install this cable correctly; if the data and
power conductors are flipped or misoriented, severe damage may be caused to the pan
tilt head, rendering it inoperable. It is easy for our technicians to tell when miswiring has
taken place due to the specific damage it causes. This type of miswiring is NOT covered
by the warranty.
Here is a table showing the correct wiring order and purpose. Please note that the connector on
the base of the head is labeled with numbers from 1 to 5: