Specifications

ITEMS INCLUDED WITH YOUR NEW PT-101 PAN TILT HEAD:
PT-101 PAN TILT HEAD
ADJUSTABLE CAMERA BRACKET
2x 1/4”-20 x 3/8” BUTTON HEAD HEX CAMERA MOUNTING SCREWS
5 PIN POWER/DATA INPUT CONNECTOR PACK
CAMERA POWER AND CONTROL CABLE
OPTIONAL: INCLUDED WITH PT-101 COMP IS A 15 PIN LOOP THRU CABLE FOR COMPO-
NENT-Y/C SIGNAL AND POWER CONNECTION
UNPACKING AND INSTALLING THE PT-101 PAN TILT HEAD
Included with this package is a graphical flow chart showing images of the correct manner of
installation. Use it in conjunction with these written instructions to complete the installation of the
PT-101 system.
Remove the PT-101 head, camera bracket and accessories from the protective foam packaging. It
is recommended to save this packaging until the installation is complete and the head has been
put into operation, in the unlikely event that there is a problem and it needs to be returned for
service.
Choose either the wall/table mounting configuration, or optional ceiling mount configuration. If
utilizing the optional PT-WM-L wall mount, make sure that the wall can support a weight of at least
45 lbs. (or 2.5 times the max. weight of the PT-101 head, camera, lens, and bracket)
If using the optional PT-CM-101 ceiling mount adapter, install the adapter on the base of the head
now using the accessory kit supplied with the adapter. Make certain that the ceiling structure can
support a weight of at least 45 lbs. (or 2.5 times the max.weight of the PT-101 head, camera, lens,
and bracket).
Attach the angle mount camera bracket to the tilt mounting disc on the side of the head. Keep in
mind that if you are ceiling mounting (inverting) the head, the angle bracket must be inverted as
well. (see photo)
Take the camera / lens assembly, place it on a desktop or other flat surface, with a pen or pencil
underneath the assembly. Carefully roll the assembly forward and back until the balance point is
found. Using the photos as a guide, loosely attach the camera/lens to the angle bracket using the
1/4-20 x 3/8” button head hex fasteners.
NOTE: It is very important to make certain the center points of the camera/lens and the
tilt disc are coincident. If they are not, the front / rear balance will be off, and the pan tilt
head may suffer performance degradation to the point of not working. Please make sure
to check the front/rear balance before calling for service.
When centered, tighten the 1/4-20 screws firmly to secure the assembly.
Attach the pre-built supplied cable harness from the rear of the pan tilt to the rear of the camera.
Note that the proper connectors are supplied for your particular camera model for power and