User Manual

USER GUIDE
67
6.14 The MicroVector’s LED Indicator
The MicroVector’s OSD provides detailed information about MicroVector status, the present flight mode, and
any errors that are detected. However, for Line of Sight flying, the LED can be used to determine the
MicroVector’s status at a glance. Here are the meanings of the MicroVector LED Indicator blinks:
Blink Pattern
Meaning
During boot-up:
MicroVector is in FIXED WING mode.
If you see this during boot on your multirotor, get
away!!!
During boot-up:
MicroVector is in MULTIROTOR mode.
If you see this during boot with your fixed wing,
disconnect power immediately!
During boot-up, after airframe indication above:
If the LED goes dark for several seconds after the
airframe indication blink above, you need to ok your
airframe type with the mode switch. Make sure the
type is correct!
An error has been detected. Check the OSD
notification area to determine the cause of the error.
See section 14 – ‘Notification Messages’ for error
message meanings.
Multirotor is armed, but an error has been
detected. Check the OSD notification area to
determine the cause of the error.
Multirotor is armed.
A 2D Flight Mode is selected
A 3D flight mode (including ‘gyro mode’) is selected
A Loiter flight mode is selected
USB mode is active