User Manual

USER GUIDE
47
high here than too low. This throttle setting will be used to gain
altitude, compensate for high wind, or attempt to recover from a stall
during RTH.
For multirotors, move your throttle stick all the way up, and toggle
Mode.
Set throttle off/Toggle Mode
Move your throttle stick all the way off, and toggle Mode.
Wizard Done-Tog Mod to reboot
The MicroVector has now learned your receiver settings. Once you click
Mode, the MicroVector will reboot, and the MicroVector’s servo outputs
will be enabled (assuming everything was done correctly).
The MicroVector will enable its outputs channels after you reboot.
MAKE SURE that your airframe type is correct before rebooting!