User Manual
 USER GUIDE 
46 
6.9 Running the Receiver Analysis Wizard 
The Receiver Analysis Wizard (the Wizard) learns about your radio 
stick directions and throws, the minimum and maximum RSSI 
output of your receiver, your receiver’s failsafe positions, and other 
information. 
  If you make a mistake when you run the wizard, just rerun 
it later. 
Before running the Wizard, make sure that you have hooked up 
your RSSI (if used), turned off any radio mixing (except as described 
earlier), and set your radio trims as desired. 
Next, invoke menu mode, select the “Run Receiver Analysis Wizard” 
menu item under the “New Airframe Checklist” menu, and follow 
the instructions below: 
Wizard Prompt 
What to Do 
REMOVE PROP(S)/Toggle Mode 
Make sure your motor(s) or propeller(s) are disabled, and toggle the 
Mode switch up and down to continue. 
  During the wizard, the MicroVector shuts off the MicroVector 
throttle output channel for fixed wing, and all the MicroVector output 
channels for multirotors. 
Turn Transmitter off now 
You have 10 seconds to turn off your transmitter. Make sure your 
transmitter is off before the countdown reaches 0! 
Turn Tx On and Toggle Mode  
Turn your transmitter back on, and toggle the mode switch once it has 
bound to your receiver. 
Hold Ailern Stick Left/Tog Md 
Hold your aileron stick full left, and while holding, toggle Mode. 
Hold Elvtr Back(Climb)/Tog Md 
Hold your elevator stick all the way back (for a climb) , and while holding, 
toggle Mode. 
Hold Rudder Stick Left/Tog Md 
Hold the rudder stick all the way left, and while holding, toggle Mode. 
  Set sticks/throt at cruise/Tg 
  Control Stick Centered/Tog Md 
  For fixed wing, make sure your control stick (aileron/elevator) is 
centered, and place the throttle in the position that you think will 
provide a good cruising speed during RTH, then toggle Mode. Note 
that you can adjust this cruising speed later in the “Advanced RTH” 
menu, even while in flight. 
  For multirotors, make sure your control stick (aileron/elevator) is 
centered, and toggle mode. The throttle position does not matter in 
this step. 
Set throttle at climb/Tog Mod 
  For fixed wing, move your throttle to a position that you think will 
provide a safe climbing throttle. It is better to have your throttle too 










