User Manual

USER GUIDE
42
If you are using a serial mode, the Wizard will ask you to follow a series of steps. These are detailed below.
IMPORTANT: follow these instructions carefully. If you make a mistake, it may be impossible to continue with
stick menu configuration, since the MicroVector menus cannot be accessed unless the MicroVector knows the
mappings for the Mode switch and the control stick. If you find you cannot invoke the menus after running the
wizard, you will need to either rewire your receiver for standard receiver input mode (using the labeled
connectors of the receiver harness) and rerun the wizard, or use the software for SPPM/S.BUS™ configuration.
Wizard Prompt
What to Do
Click Mode to Learn Serial Rx
For this step, toggle the switch that you want to be the Mode switch. If the
MicroVector detects the toggle, the wizard will advance.
REMOVE Prop(s)/Toggle Mode
Make sure your motor(s) or propeller(s) are disabled, and toggle the Mode
switch up and down to continue. Note: all MicroVector outputs are
disabled during the wizard.
Throttle Up and Toggle Mode
Move your throttle to the full up throttle position, and toggle Mode.
Throttle Off/Toggle Mode
Move your throttle to the off position, and toggle Mode.
Hold Aileron Left/Toggle Mod
Hold your aileron stick full left, and while holding, toggle Mode.
Hold Elvtr Back(Climb)/Tog
Md
Hold your elevator stick all the way back (for a climb), and while holding,
toggle Mode.
Hold Rudder Stick Left/Tog Md
Hold the rudder stick all the way left, and while holding, toggle Mode.
Flip Submode if Used/Tog
Mode
If you are going to use a Submode switch, move that switch to a new
position (don’t move it back) and toggle Mode. If you are not going to use
it, just toggle Mode without moving any switches.
Rotate Gain if Used/Tog Mode
Rotate the Gain knob to a new position (make sure that it moves at least
40% of its maximum turn) and toggle Mode. If you are not going to use it,
just toggle Mode without moving any knobs.
Kill switch on if Used/Tog
Md
If you wish to use a Kill switch for your multirotor, change its position
(hold it in the new position if it’s momentary) and toggle Mode. If you are
not going to use it, just toggle Mode without moving any switches.
Note: the kill switch is mandatory if the High Perf Mini Quad
airframe type is chosen.
Flip Flaps Sw if Used/Tog
Md
If you wish to use a flap switch or knob with the MicroVector, change its
position and toggle Mode. If you are not going to use it, just toggle Mode
without moving any switches.
Learn Done! Clik Md to reboot
The MicroVector has now learned your serial Rx mappings. Click the
mode switch to reboot, and continue with the steps below.
If you ever need to change your serial mappings later, just invoke the “Serial Rx Input Learn Wizard”
menu item in the Radio Control Settings menu.