User Manual

USER GUIDE
39
6.3 Transmitter Channel Mixing
For correct operation, you must make sure that you have disabled channel mixing in your radio, since the
MicroVector does the mixing for you.
For example, if you are using an elevon (flying wing) model, your radio must be configured for
traditional airframe type rather than elevon type.
Note: If you have selected the traditional fixed wing airframe type, and have secondary control surfaces like
dual ailerons or flaperons, you can either have the transmitter do the mixing, or have the MicroVector do
simple mixing.
6.4 Configuring with the Windows Software
The manual focuses primarily on configuring the MicroVector using the stick menus, but the concepts are the
same for the software.
Generally, the MicroVector can be more quickly and easily configured with the software, especially for first
time users. However, both methods have been made as straightforward as possible.
To configure with the Software, follow these high level steps. These steps primarily refer to the “Overview”
screen shown below:
1) Read through the rest of the manual to understand the setup steps, warnings, etc.
2) Run the software with the MicroVector connected to USB. You will also need to have your transmitter
bound to your receiver and functioning correctly.
3) Select your airframe by clicking the “Choose Airframe” button.
4) Run the Receiver Analysis Wizard by clicking the “Run Rx Analysis Wizard” button.