User Manual

USER GUIDE
130
15 Description of Numeric Readouts
The following numeric readouts can be configured for display. Some require optional hardware.
Numeric Readout Name
Description
Main Pack Voltage
Voltage of the pack connected to the current sensor
Receiver Voltage
Voltage at the MicroVector’s servo outputs
Barometric Altitude
Zero referenced altitude, from the onboard pressure sensor
Pitot Airspeed
Airspeed from the optional pitot airspeed sensor
Main Pack Current
Current flowing through the current sensor
Main Pack Wattage
Voltage X Current at the current sensor
Main Pack mAH Used
The milliamp hours through the current sensor since bootup
Mode Rx Input %
The measured pulsewidth at the MicroVector’s mode switch input (0% = 1
millisecond, 100% = 2 milliseconds)
Gain Rx Input %
The measured pulsewidth at the MicroVector’s gain knob input, if used
Aileron Rx Input %
The measured pulsewidth at the MicroVector’s aileron input
Elevator Rx Input %
The measured pulsewidth at the MicroVector’s elevator input
Throttle Rx Input %
The measured pulsewidth at the MicroVector’s throttle input
Rudder Rx Input %
The measured pulsewidth at the MicroVector’s rudder input
Submode Rx Input %
The measured pulsewidth at the MicroVector’s submode switch input, if used
Kill Switch Rx In %
The measured pulsewidth at the MicroVector’s kill switch input, if used
2nd Aileron Rx In %
The measured pulsewidth at the MicroVector’s 2
nd
Aileron input, if used
2nd Elevator Rx In %
The measured pulsewidth at the MicroVector’s 2
nd
Elevator input, if used
2nd Rudder Rx In %
The measured pulsewidth at the MicroVector’s 2
nd
Rudder input, if used
Aileron/M2 Output %
The pulsewidth being sent to the MicroVector’s Aileron/M2 output (0% = 1
millisecond, 100% = 2 milliseconds)
Elevator/M3 Output %
The pulsewidth being sent to the MicroVector’s Elevator/M3 output
Throttle/M4 Output %
The pulsewidth being sent to the MicroVector’s Throttle/M4 output
Rudder/M1 Output %
The pulsewidth being sent to the MicroVector’s Rudder/M1 output
Aux1/M5 Output %
The pulsewidth being sent to the MicroVector’s Aux1/M5 output, if configured