User Manual

USER GUIDE
127
GPS Status: Awaiting Enough Sats
Indicates that the MicroVector is waiting for the GPS to acquire enough
satellites. See GPS Configuration menu.
GPS Status: Awaiting HDOP
Accuracy
Indicates that the MicroVector is waiting for the GPS to have a low
enough HDOP (Horizontal Dilution of Precision). See GPS Configuration
menu.
GPS Status: Post-Fix Countdown
Indicates that the MicroVector is waiting for the amount of time
specified after the GPS fix is finalized, in the GPS Configuration menu.
GPS Not Connected!
The MicroVector has detected that the GPS is not connected. Check
cabling.
GPS Fix Lost!
This indicates that the GPS has lost its position fix. All GPS modes,
including RTH, will be disabled until it regains a fix.
GPS/Compass has old Firmware!
This message indicates that the firmware on the GPS/MAG needs to be
updated. GPS/Mag firmware updates automatically occur when you
update the MicroVector firmware, as long as you have the GPS/MAG
connected to the MicroVector at the same time.
Gyro not detected!
If you repeatedly see this message, DON’T FLY and contact support.
Home Waypoint too far away!
You set up a Home Waypoint in the software, but that waypoint is more
than about 500 feet (152 meters) from the GPS’s first fix location.
Idle throttle being reduced!
The MicroVector has detected that you are commanding the multirotor
to descend by throttling down, but the multirotor is not descending,
possibly due to too high of an idle throttle setting. Please land and
reduce your idle throttle.
Impact Detected!
This message tells you what you probably already knew. :(
Kill Switch Activated!!
This message appears when you activate the motor kill switch.
Landing - Poor GPS or Mag
This message indicates that the model is landing (normally during RTH)
if the GPS signal or compass calibration is too poor to continue returning
home.
Lipo cell count incorrect?
This message is displayed at boot when low battery autoland is enabled,
and you have connected either an almost dead battery, or a battery that
is overcharged. If you have manually defined the number of cells in your
battery for the autoland function, this message will also be displayed if
the detected cell count does not match the stated number.
Logging Buffer is Full
This message will appear when the data logging buffer is full, if you have
disabled automatic clearing of the logging buffer.
Loiter Off - Poor GPS or Mag
This message indicates that loiter is being disabled due to poor GPS
signal or compass calibration.
Low Battery Voltage Detected!
This message is displayed during flight if low battery autoland is
enabled, and if the minimum cell voltage you specified has been reached.
Magnetometer not detected!
This message will appear if the compass is enabled, but not detected
(normally due to the GPS/MAG being unconnected).
Maximum Altitude Exceeded!
The maximum altitude you programmed on the RTH/Safety Mode page
has been exceeded.
Maximum Distance Exceeded!
The maximum distance from home you programmed on the RTH/Safety
Mode page has been exceeded.
Memory malfunction detected!
If you repeatedly see this message, DON’T FLY and contact support.
Menus disabled during flight!
This message appears if you have not enabled in-flight menu access
(under Advanced Radio Control) and you attempt to enable menu mode
during flight.
Mode Switch not detected
detected!
This message will appear during boot-up if the mode switch signal input
is not detected.
Motor Kill Input not Detected
This message will appear during boot-up if you have configured a motor
kill switch, the switch signal input is not detected.