User Manual

USER GUIDE
122
audio channel (left or right) that is coming from the MicroVector is
the same one you are listening to on the ground.
Video: I am seeing video
“smearing” or lines on the video
screen, that correspond with the
location of text on the screen.
Increase your MicroVector “Black Level” setting in the OSD Setup menu.
Video: I am having trouble
reading the MicroVector text
through my goggles.
 Try increasing or decreasing the “Black Level” setting in the OSD
Setup menu.
 Increase the “Color Brightness” in the Color Setup menu.
 If a particular color is hard to read, either set intensity of that color
to “High”, or change your settings to not use that color, in the Color
Setup menu.
 Select “White” for “Numeric Parameters Color” in the Color Setup
menu. Then, the “White Level” setting in the OSD Setup menu will
let you change the brightness of the white text.
I am having problems with my
MicroVector which I haven’t
been able to resolve otherwise.
 Make sure you are running the latest MicroVector firmware, as
described in section 2.5.2.1 – ‘Updating your MicroVector
Firmware’.
 Consider performing a “Factory Reset” on your MicroVector, which
will restore the MicroVector to factory defaults. This can be done
either with the “Factory Reset” button in the software (at the
bottom of the screen) or with the option in the Advanced Radio
Control stick menu.
Software: the configuration does
not launch, or exits shortly after
starting.
 Try running the software in Windows XP Compatibility mode
 Try running the software “As Administrator”
The MicroVector is not detecting
my receiver’s S.BUS
TM
output.
If using S.BUS2™ with the Futaba™ RX R7008SB receiver, be sure you
select FASTTtest™ 18 channel or 14 channel modes and link to the
receiver from the transmitter’s menu.
My receiver does not turn on.
The MicroVector does not power your receiver or servos. You will need
to power your receiver and servos as you would in a non-MicroVector
model, such as with a stand-alone BEC, a BEC built into your ESC, or a
separate battery pack.
Whatever power is provided to your receiver will be routed through the
MicroVector to your servos, via the Receiver Connection Harness.
Whatever power is provided by an ESC’s BEC will be routed through the
MicroVector to your receiver and servos.
You can alternatively use the 5 volt tap from the PSU (if not being used to
power a 5 volt camera or video TX) to power your receiver on multirotors.
Please see section 4.5.3 - ‘Powering your Standalone Receiver on
Multirotors’ for additional info.