User Manual

USER GUIDE
109
12.4.2 The Waypoint Setup Tab
Refer to the lettered indications on the diagram below:
A: The waypoint map
B: The Command Index column of the waypoint command table
C: The Command Type column of the waypoint command table
D: When clicked, the waypoint map will be displayed in full screen mode. Hit ESC to exit full screen mode.
E: When clicked, low altitude waypoint navigation will be enabled. Enable this option only if you need your
model to fly low to the ground during waypoint navigation. Leaving this unchecked will limit all waypoints at
execution time to a minimum of 49ft (15m) above the home position ground level. CAUTION: enabling this
option greatly increases the likelihood that your prop(s) will spin on the ground when waypoint mode is
enabled!
F: When clicked graphical “birds-eye” view graphical waypoint icons will be displayed on the OSD screen, when
Waypoint flight mode is selected. See description of graphical waypoints later in manual.
G: Flight distance indicates the approximate total distance between the first and last waypoint. Flight distance
does not factor in Jump instructions.
H: The Session name is set when a waypoint session is either saved or loaded.
I: Click this button to insert a Waypoint Command after the presently selected command.
J: Each time a waypoint is added, the system will set its altitude to this default value. You can edit the waypoint
altitudes later as needed, to override the default.
K: This button deletes the selected command.