User Manual

USER GUIDE
102
2) Leave the MicroVector completely unpowered for at least 30 minutes.
3) Have your transmitter ready, and apply power to the MicroVector (do this indoors).
4) Within 1 minute (the quicker the better) navigate to the Calibration and Sensors menu, select the
“Altimeter cal (read manual)” item, and click the mode switch.
5) Don’t move the MicroVector until the calibration process completes (about 3 minutes).
6) The calibration result (pass or fail) will remain in the notification area after the process completes.
8.5.3 Pitot Airspeed Calibration
If the optional pitot tube airspeed sensor is being used, and you find that the airspeed readings are too high
or low, the "Airspeed Sensor Factor” on the Calibration screen can be used to adjust it. Increase this value
if your pitot speed is too low, and vice versa.