User Manual

USER GUIDE
10
2 Overview
2.1 Introduction
Thank you for your purchase! Based on Eagle Tree's proven inertial stabilization and video technology, the
MicroVector Flight Controller + OSD has everything we’ve dreamed about, in one small, lightweight, easy to use
product:
Flight Controller
• Simple setup and configuration using OSD stick menus, Windows GUI, or InfoPanel
LCD
• Precise, low latency DMA enhanced control loop running at up to 8K, with support for
“OneShot” and “MultiShot” ESC protocols
• Configure and update most BLHeli
TM
based ESCs through the MicroVector’s USB port
• Programmable video power control: Turn on/off your video camera and/or
transmitter using a radio switch, on arm/disarm, etc.
• Standard 30.5mm mounting hole centers
• Multirotor airframes: high performance Mini Quad, quad, Tricopter, Y6, hex
• Fixed wing airframes: traditional, elevon, v-tail
• With GPS module, supports advanced GPS flight modes, RTH, and waypoints
• PWM, SPPM, Spektrum
TM
Satellite, and S.BUS
TM
Receivers supported, with 4 types of RSSI
• Onboard altimeter for altitude hold flight modes
• Full data logging and graphing
• UART for telemetry, including ET Open Telemetry and Taranis™
OSD
• Graphical OSD with COLOR GRAPHICS and fully customizable screens (make
it look as simple or robust as you like!)
• Built in OSD menus allow full configuration of most features without using a
computer
• Supports SkyGates virtual racing (Experimental Augmented Reality, optional
GPS required)
2.2 Packing List
Your package should include the following:
 Vector Controller with Plastic Case (4 phillips screws)
 Total of 5 “Pigtail” harnesses for ESC output, Receiver input, video and power (requires soldering to
ESCs, etc.)