Instructions for use

Page 7

Updating the eLogger’s Firmware

Each time a new version of our software is installed, the software will

check the firmware version of the eLogger, and will prompt you to

update the firmware if a new version is available. Always update the

firmware if prompted to do so. When new firmware is available, the

“Firmware Control” screen will appear. Simply click the “Click Here

to Update Recorder Firmware Version” to start the firmware update

process.

Setting up the eLogger with the

Windows Software

Once the software is installed, run the software as described above.

The first time the software is launched, the New Model Wizard will be

invoked.

The Wizard will prompt you to install the eLogger using the supplied

USB cable.

When you do this for the first time, the behavior will be different

depending on which version of Windows you are using:

Windows 7™, Windows Vista™, Windows 2000 ™ and Windows

XP ™: When the eLogger is first connected to the USB port,

Windows should automatically install the correct drivers without prompting you. If you should receive a Windows prompt, however,

do what it says.

Windows 98SE™ and Windows Millennium™: When the eLogger is first connected to the USB port, the New Hardware Wizard

will likely appear. Follow the steps in the Wizard, choosing the options to allow Windows to find the appropriate drivers for the

eLogger – these drivers are built into Windows. If the devices you already have on your computer haven’t required the installation of

the USB drivers, Windows will prompt you for your Windows CD to copy over the drivers. Once this process is complete, you may

be asked to reboot the system. Reboot at this point, then launch the eLogger Software, and the New Model Wizard should start up

again.

Windows 98™: The eLogger and software are not compatible with Windows 98.

Telling the eLogger what to Log

The first time you run the software, you will be prompted to choose what parameters you wish the eLogger to record, using the

dialog box shown below. Note that this dialog box can be accessed at any time, by clicking “Hardware, Choose Parameters you want

to Log in the Recorder.”