Instructions / Assembly

WARNING:

Proper use of the chair is for single person seating only. The chair is not to be used for

standing purposes and will not function as a stool or step-ladder. Use on even surfaces

only. Sofa tested for use at weight of 300 lb. Table tested for use at weight of 110 lb.

Improper use of this product or failure to use as directed may result in injury. Not

intended for commercial use.

IMPORTANT:

Please read all the instructions and warnings before assembling. In order to make the

whole product adjust to the best, please install all the screws on the product before

fully tighten and note to put the washer to the screw before putting the screw into the

screw hole.

SAFETY INFORMATION:

· Keep all children and pets away from assembly area. Children and pets should be

supervised when they are in the area oft he product construction.

· Keep assembly area at least 6 feet from any obstruction such as a fence, garage,

house, overhanging branches, laundry line or electrical wires.

· Some parts may contain sharp edges. When assembling and using this product, basic

safety precautions should always be followed to reduce the risk of personal injury and

damage to the product. Please read all instructions before assembly and use.

· Check all bolts for tightness before use, IMPORTANT-check and tighten bolts often to

keep them secure!

· The chair is not to be used for standing purposes and will not function as a tool or

step-ladder. Use on even surfaces only.

· The sofa use at weight of 300 lb. Improper use of this product or failure to use as

directed may result in injury. Not intended for commercial use.

CARE&MAINTENANCE:

· STAIN RESISTANT CUSHIONS CARE: KEEP THE CUSHIONS IN STORAGE IN RAINY

DAYS

· SPILLS: Immediately wipe up the spill using a white damp doth. Repeat process if

necessary until stain is gone. Allow cushion to air dry.

· FABRIC CARE: Hand wash only, non-chlorine bleach when needed, lay at to dry. Cool

iron if necessary. Do not dry clean.

· RESIN WICKER PRODUCT CARE: Before using, clean the product completely with a soft

dry towel. When not in use, wipe free of any dirt or loose objects, wash with a mild

solution of soap and water, rinse thoroughly and dry completely. Do not use strong

detergent or abrasive cleaners. Over time nuts and bolts can loosen. Occasionally,

check nut and bots on all chairs and tables, re-tighten if necessary.