User`s guide

Monitors and Cameras
Polycom, Inc. 3–11
Using Dual Monitor Emulation in a Call
During calls using Dual Monitor Emulation, users can press the Display
button on the remote control to scroll through the following screen layouts:
1 Near and far sites, same size, side by side
2 Far site big, near site small
3 Near site big, far site small
4 Near site, full screen
5 Far site, full screen
The last layout viewed is used for the next call.
Configuring Multipoint Viewing Modes
To configure multipoint viewing modes:
1 Do one of the following:
— In the local interface, go to System > Admin Settings > Monitors >
Multipoint Setup.
— In the web interface, go to Admin Settings > Monitors > Multipoint
Setup.
For information about using Dual Monitor Emulation in a call when the Polycom
HDX system is paired with a Polycom Touch Control, refer to the User’s Guide for
Polycom HDX Systems and Polycom Touch Control Device.