Specifications

3. Take a Hex screw driver and secure the bracket by screwing in the 2 pre-installed screws.

These screws will engage with the corners of the fan vents.

4. Take the second bracket without the PSU space and attached it to the other side of the E7

furthest from the power inlet in the same way. This is also secured by screwing the 2

pre-installed screws into the corners of the vents.

5. Take the external power supply and place it into the space provided on the PSU bracket.

Gather the spare power cord into a bundle and secure this against the PSU as well as the

PSU itself by looping the provided plastic cable tie around both, passing it through the

holes provided in the bracket.

Chapter 3: E7 Installation