User's Manual

STARTING THE TERMINAL
• Press the call selector. The terminal emits an information beep.
The message “
WWAAIITT
” and the address of the terminal flash for a few
seconds (terminal initialisation).
The home message is then displayed:
• if the terminal is under network coverage: the registration symbol and
the received field strength are displayed,
• otherwise, the registration symbol and the received field strength are
not displayed.
The terminal is under The terminal is not under
network coverage network coverage
When the terminal is registered, the call selector returns to the last
position selected before the terminal was turned off. If a call was
associated with this position, it is automatically sent.
N.B.:
Any of the following messages may be displayed in place of the home
message:
• "
RREECCEEIIVVEEDD MMEESSSSAAGGEESS
": the terminal has received one or more
messages (see Message Menu chapter)
• "
RREECCEEIIVVEEDD CCAALLLLSS
": the terminal has received one or more calls
(see Message Menu chapter)
• "
FFOORRWWAARRDDEEDD
": if the "
FFOORRWWAARRDD
" function has been deactivated (see
Main Menu to deactivate it)
TURNING OFF THE TERMINAL
• Press and hold down the call selector. The terminal emits an information beep, then
switches off.
On/Off button
Call selector
MC 2610
How to use the terminal
8
** MM CC 22 66 00 00 **
00 11
** MM CC 22 66 00 00 **
00 11
77 88 00 22 55 00 33 00 00
WW AA II TT
CCP MC2 V35 EN LB 17/10/01 14:12 Page 8