User's Manual

PRIORITY SCAN SEQUENCE
Starting the scan
Starting a scan is only possible under the following circumstances:
• the terminal must be under priority open channel coverage,
• the priority open channel must be available under the station,
• if it is a 6-figure priority open channel, the terminal must be registered
in the BN corresponding to the BN of the priority open channel.
Otherwise, it is not possible to start the scan and the request
is put on hold ("
SSCCAANN
" flashes on display). The terminal then becomes
candidate to scanning and displays, for example:
"
OOCC 1122
" (number of priority
open channel) and "
SSCCAANN
" flash
When the priority open channel is available, the scan starts
("
SSCCAANN
" displayed steady on) and searches for an active call.
The terminal displays, for example:
Display steady on
Talking – Activating the priority open channel
If you press the Push-to-talk key or if the priority open channel
is activated, the terminal listens to the open channel and displays either:
or
Terminal in transmit mode Terminal listening,
speaker's address displayed
You are communicating in the priority open channel.
When the priority open channel is active, the terminal ignores any
activation of non-priority open channels.
Scan
54
OO CC 11 22 SS CC AA NN
00 11
OO CC 11 22 SS CC AA NN
00 11
OO CC 11 22
SS 00 11
77 88 00 22 00 00 33 22 55
OO CC 11 22
SS 00 11
CCP MC2 V35 EN LB 17/10/01 14:12 Page 54