User's Manual

Procedure in the event of a problem
108
OTHER OPERATING PROBLEMS
The terminal displays:
1- The number (of the called party or open channel) is
unknown to the network. Enter another number.
2- The terminal is not registered with the network. Wait
until the registration symbol " " and the
field strength " " are displayed before you
can access network services. Direct mode
communications are possible.
3- Access to the service requested is not authorised
(service not available or barred when the terminal was
customised).
4- Access to the service requested is temporarily
unavailable. Try again later.
5- Available depending on the hardware version.
The terminal has detected:
- either a problem with the terminals installation (no
antenna, antenna not connected properly, terminal-
antenna cable cut, etc.) or a radio problem in the
terminal when it tries to transmit between 5W and
10W,
or
- a very high temperature inside the
transmitter/receiver unit (BER).
The transmit level is automatically reduced to 5W to
protect the BER. The terminal remains operational but
with a reduced range. The message is automatically
erased after a few seconds or immediately if is
pressed. Contact the technical support service or refer
to the Terminal Technical Manual.
CLR
UU NN KK NN OO WW NN
NN UU MM BB EE RR
00 11
NN OO TT
RR EE GG II SS TT EE RR EE DD
00 11
FF OO RR BB II DD DD EE NN
SS EE RR VV II CC EE
00 11
RR EE FF UU SS EE DD
SS EE RR VV II CC EE
00 11
TT RR AA NN SS MM II TT
PP RR OO BB LL EE MM
00 11
CCP MC2 V35 EN LB 17/10/01 14:12 Page 108