Installation Instructions

FIXED TERMINAL INSTALLATION HANDBOOK
E
N
G
L
I
S
H
41/42
This document is the property of MATRA NORTEL COMMUNICATIONS and should not be copied or circulated without permission
IH – PS8433EAE01 09/2001
5.3 PUTTING THE TERMINAL INTO SERVICE
• Switch on the fixed terminal by pressing the call selector – On/Off
button of the CCP (see Figure 5.1) or the key of the handset
(see Figure 5.2).
The terminal emits two consecutive beeps and the message “WAIT”
is displayed for a few seconds,
AIWT
AIWT
followed by the welcome message
*MC 6
0*CM60*
00*
9
9
Note: In certain cases the project name replaces the “*MC9600*”
message, on the display and on the handset printing.
In the case of a fixed radio terminal, the registration process is initiated
until the antenna symbol , and the field level symbol are
displayed.
*MC 6
0*CM60*
00*
9
9
In the case of a line connected terminal, the line connected
registration symbol f replaces the field level symbol .