Installation Instructions

Table Of Contents

(Plate A–VI)

(Plate A–VII)

FIXED TERMINAL INSTALLATION HANDBOOK

37/42

This document is the property of MATRA NORTEL COMMUNICATIONS and should not be copied or circulated without permission

IH – PS8433EAE01 09/2001

4.3.9.2 Smart or Easy+ CCP

• Position the CCP (item 8) near its desk holder (item 2).

• Connect and lock the Sub–D 25–pin female connector (item 3) of the

CCP desk holder–wall unit link cable to the Sub–D 25–pin male

connector of the CCP rear panel (item 8).

• Put the CCP on the desk holder and push it until it is locked on each

side.

• Connect the connector (item 7) of the ELNO gooseneck microphone

cable to the female connector of the CCP front panel.

Note: Two extraction keys (item 6) are supplied with the CCP. These are

used to remove the CCP from its holder. To do this:

• place a key (item 6) on each side of the CCP (item 8) turning

the pins inwards,

• insert the two keys (item 6) in the lateral openings of the

desktop holder,

• press the keys (item 6) to unclip the CCP on each side,

• remove the keys (item 6) and the CCP (item 8).

4.3.10 Handset desktop set

• Position the handset desktop set bracket (item 2) on the desk.

• Connect the DIN connector (item 3) of the handset (item 1) to the left

hand side connector of the desktop set bracket (item 2) and then

secure it by screwing the ring of the handset cable connector.

• Install the handset (item 1) on the desktop bracket (item 2).

• Connect the Sub–D 15–pin female connector of the handset desktop

set – wall unit link cable to the “COFFRET/UNIT” connector (item 4) of

the bracket (item 2).