Installation Instructions

(Plate A–VI)
FIXED TERMINAL INSTALLATION HANDBOOK
E
N
G
L
I
S
H
36/42 09/2001
IH – PS8433EAE01
This document is the property of MATRA NORTEL COMMUNICATIONS and should not be copied or circulated without permission
4.3.9 CCP desktop set
4.3.9.1 CCP desktop support
• Place the CCP holder (item 2) on the desktop plate (item 5); the two
holes of the holder must be aligned with the two threaded holes of the
desktop plate.
• Secure the CCP holder (item 2) using the two screws (item 1) supplied
with the desktop plate. Tilt the holder cradle to the rear to facility
access to the screws.
• Remove the cable guide ring (item 4) from the rear panel of the CCP
holder.
• Insert the Sub–D 25–pin female connector (item 3) of the CCP desk
holder–wall unit link cable in the opening of the rear panel of the CCP
holder.
• Put the cable guide ring (item 4) on the CCP holder–wall unit link cable.
Make sure that the cable guide ring is the right way round.
• Install the cable guide ring (item 4) on the rear panel of the CCP holder.