Installation Instructions

(Plate A–III)
FIXED TERMINAL INSTALLATION HANDBOOK
E
N
G
L
I
S
H
35/42
This document is the property of MATRA NORTEL COMMUNICATIONS and should not be copied or circulated without permission
IH – PS8433EAE01 09/2001
4.3.7 Connecting the wall unit
Power supply cable
• Check that the On/Off switch of the power supply is set to the off
position.
• Connect the power supply cable to the power supply connector
(item 7).
• Route the power supply cord through one of the two feed–through
possibilities of the wall unit (see Figure 4.3).
• Connect the power supply cable to the mains.
Antenna cable (fixed radio terminal)
• Install the elbowed TNC connector on the wall unit “ANTENNE –
ANTENNA” connector.
• Connect the antenna cable to the elbowed TNC connector, observing
the safety precautions given in Chapter 3.
RSW – wall unit link cable (line–connected terminal)
• Connect the RSW – wall unit link cable to the wall unit “CG/CS –
MSW/SSW”; make sure that the 8–pin female connector is fitted the
right way round (keying) and attach the cable to the unit via the
RILSAN type clamp provided.
4.3.8 Fixed RT – desktop set link cable
• Connect the fixed RT – desktop set link cable to the wall unit
“P.PRINCIPAL – DESKTOP SET” connector. Tighten the two link
cable connector screws.
• Route the desktop set–wall unit link cable to the selected location for
the desktop set, following the safety instructions given in Chapter 3.