Installation Instructions

(Plate A–IX)
(Plate A–X)
MOBILE TERMINAL INSTALLATION HANDBOOK (BER VERSION B)
E
N
G
L
I
S
H
29/32
This document is the property of MATRA NORTEL COMMUNICATIONS and should not be copied or circulated without permission
IH – PS8432EAE01 09/2001
4.3.8.2 CCP dashboard holder
Note: The CCP dashboard holder allows the CCP to be installed on
a dashboard or on all horizontal surfaces.
• Position the CCP dashboard holder (item 9) in its location.
• Secure the CCP dashboard holder (item 9) using the two
screws (item 8). Tilt the holder cradle to the rear, to facilitate access to
the screws.
• Remove the cable guide ring (item 11) from the rear panel of the CCP
dashboard holder (item 9).
• Insert the system cable connector (item 10) in the opening of the rear
panel of the CCP dashboard holder.
• Put the cable guide ring (item 11) on the system cable. Make sure the
cable guide ring is the right way round.
• Install the cable guide ring (item 11) on the rear panel of the CCP
dashboard holder.
4.3.8.3 CCP
• Position the CCP (item 4) near its car DIN holder (item 5) or
dashboard holder.
• Connect the Sub–D 25–pin female system cable connector (item 6) to
the Sub–D 25–pin male connector of CCP (item 4) rear panel.
• Put the CCP on the holder and push it until it is locked on each side.
• Connect the speaker microphone (item 2) connector (item 3) to the
front panel connector of CCP.