Installation Instructions

(Planche A–VII)
MOBILE TERMINAL INSTALLATION HANDBOOK (BER VERSION B)
E
N
G
L
I
S
H
26/32 09/2001
IH – PS8432EAE01
This document is the property of MATRA NORTEL COMMUNICATIONS and should not be copied or circulated without permission
4.3.7 Tansceiver version B
CAUTION: It is recommended not to hinder the natural convection
around the transceiver installed in the vehicle. If,
however, under exceptional, temporary circumstances,
the car terminal is installed in a box, such a box should not
be smaller than the box for the motor–bike terminal option
unit (minimum dimensions: 270 x 255 x 105 mm).
4.3.7.1 Preparing the BER
Note: Before installing the BER, make sure it has been loaded,
configured and customised via the TPS (see Section 1.3,
Document <1>).
• Place the gasket (item 4) on the radio BER version B (item 1) or wide
band radio BER version B (item 3) Sub–D 25–pin male operating
connector (item 2),
Note: The gasket (item 4) is supplied with the connector kit HT1107
contained in car kits HT1108A and B and with the system
cable kit HT6237 contained in car kits HT1108C and D.
The gasket should still be fitted on the wide band radio
BER Sub–D 25–pin male connector even if the connector
already has a gasket fitted.
• Terminal with car kit HT1108A or B: fit the Sub–D 25–pin adapter
( item 5):
connect the Sub–D 25–pin adapter (item 5) to the BER (item 1 or 3)
Sub–D 25–pin male operating connector (item 2),
secure the adapter (item 5) with the two spacers (item 6).