Installation Instructions

MOBILE TERMINAL INSTALLATION HANDBOOK (BER VERSION B)
E
N
G
L
I
S
H
25/32
This document is the property of MATRA NORTEL COMMUNICATIONS and should not be copied or circulated without permission
IH – PS8432EAE01 09/2001
The transceiver bracket is secured by 4 screws or other means. The
length and the type should be adapted to the type of vehicle surface.
When using studs or threaded rods check that the length of threaded rod
(item 12) coming out from the bottom of the transceiver bracket boss do
not exceed 9 mm. If the length is more than 9 mm, insert a positioning
washer under the transceiver bracket or reduce the length of the threaded
rods.
Make the connections corresponding to the type of BER bracket:
• BER bracket, reference HR1348 (item 6):
connect the system cable Sub–D 15–pin male connector (item 1) to
the BER bracket Sub–D 15–pin female connector (item 2),
tighten the two system cable connector screws,
connect the power supply cable 2–pin AMP female connector
(item 4) to the BER bracket 2–pin AMP male connector (item 3)
and make sure they are properly locked together,
• BER bracket, reference HR6237 (item 10):
connect the system cable 2–pin AMP male connector (item 7) to
the BER bracket 2–pin AMP female connector (item 8) and make
sure they are properly locked together,
connect the power supply cable 2–pin AMP female connector
(item 4) to the BER bracket 2–pin AMP male connector (item 9)
and make sure they are properly locked together,