Installation Instructions

(Plate A–V)
(Plate A–VI)
MOBILE TERMINAL INSTALLATION HANDBOOK (BER VERSION B)
E
N
G
L
I
S
H
24/32 09/2001
IH – PS8432EAE01
This document is the property of MATRA NORTEL COMMUNICATIONS and should not be copied or circulated without permission
4.3.5 External loudspeaker (optional)
• The loudspeaker should be installed according to the manufacturer’s
recommendations and the safety precautions given in Chapter 3.
• Route the loudspeaker cable to the loudspeaker connector on the
system cable (item 13).
• On the loudspeaker cable, connect the MOLEX 2–pin male connector
included in the system cable kit:
cut any connectors on the loudspeaker cable (items 16 and 18),
strip the two loudspeaker wire ends,
crimp the two MOLEX connector contacts (item 15),
insert the contacts into the connector (item 14) following the
polarity shown in Plate A–V,
connect the loudspeaker cable connector to the system cable
connector (item 13).
4.3.6 Support BER version B – HR1348 or HR6237
The transceiver bracket should be installed according to the safety
precautions given in Chapter 3.
For the installation position of the transceiver bracket, the following
precautions must be applied:
• access to the transceiver must be free and allow the transceiver to be
easily installed and removed,
• connection of the cables must be free and without constraint for the
cables and their connector, respecting the bending radius of the cable.
• the BER should be positioned so as to be kept as cool as possible.
Use the positioning washers (item 11) and damping column of the
screwing kit to seat the transceiver bracket so as to protect it from
vibration. Check that the transceiver bracket is still seated on its 4 bosses
(item 5).