Installation Instructions

MOBILE TERMINAL INSTALLATION HANDBOOK (BER VERSION B)
E
N
G
L
I
S
H
23/32
This document is the property of MATRA NORTEL COMMUNICATIONS and should not be copied or circulated without permission
IH – PS8432EAE01 09/2001
• Install on the + battery wire the fuse holder (item 5) and fuse (item 4)
assembly supplied with the connection kit:
Note: The fuse holder and fuse assembly must be placed near the
battery.
cut the + battery (item 2) wire and strip about 20 mm from the two
wires,
insert each stripped wire into the fuse holder,
crimp the + battery wire on each side of the fuse holder : crimp
directly on the fuse holder (items 3 and 6) dull surfaces,
place the fuse (item 4) in the fuse holder (item 5).
• If necessary, install a battery clip on each wire of the power supply
cable.
4.3.4 System cable
The radius of curvature of the system cable inside the vehicle must not
exceed 20 mm.
The cable system must be installed according to the instructions detailed
in Chapter 3. The system cable terminal connections must be near the
locations of the different equipment of the mobile terminal (CCP,
transceiver, etc.).
The length of the system cable is either 7.5 meters or 10 meters. Each
system cable terminal connection (to the CCP bracket, to the external
loudspeaker and to the mobile data terminal) is 1 meter in length.