Installation Instructions

(Plate A–V)
MOBILE TERMINAL INSTALLATION HANDBOOK (BER VERSION B)
E
N
G
L
I
S
H
22/32 09/2001
IH – PS8432EAE01
This document is the property of MATRA NORTEL COMMUNICATIONS and should not be copied or circulated without permission
4.3.2 Antenna cable
• Route the antenna cable to the BER transceiver, taking care to
respect:
the safety precautions given in Chapter 3,
the radius of curvature recommended by the coaxial cable
manufacturer.
• On the antenna cable end, connect a TNC connector.
4.3.3 Power supply cable
• Route the power supply cable from the vehicle battery to the BER
transceiver bracket following the safety precautions given in
Chapter 3.
• On the BER transceiver bracket side, connect the AMP 2–way female
connector (item 9) supplied in the connection kit:
strip the two wires of the power supply cable (item 12),
put a sealing ring (item 11) on each wire, positioning the small
diameter towards the connector,
crimp the contacts (item 10) on the two power supply wires,
insert the contacts into the connector (item 9) with the +12 V
battery on terminal 2 of the connector and the vehicle earth on
terminal 1 of the connector,
lock the two contacts in the connector by pushing on the locking
cage (item 8) located at the front of connector ,
insert the two sealing rings into the openings of the connector.