User Manual E160 This product is compatible with FUTABA 2.4GHZ S-FHSS regulations. Brushless motor, super power, compatible with 3-axis gyroscope and 6-axis gyroscope modes, 3-axis for ultra-stable flight and 6-axis for beginners.
ITEM LIST NO. PARTS QUANTITY 1 Gift Box 1 2 Sports backpack 1 3 User Manual 1 4 Helicopter 1 5 Transmitter 1 6 Charger 1 7 Battery 7.
NOTICE TABLE OF CONTENTS All instructions, warranties and other collateral documents are subject to change at the sole discretion of our company. For up-to-date product literature, please visit www.eachine.
HELICOPTER PARAMETERS Length 345 MM Height 108MM Weight 156g Length of Main Propeller 350MM Diameter of Tail Propeller 62.5MM Battery Specification 7.4v 700mah 25C Flight Time 5-6 Min Main Brushless Motor 1312 Brushless Tail Motor 1103 WARNING AND THE GUIDE OF BATTERY USAGE Warning 1. To ensure safety, please charge under the supervision of someone. 2. Children cannot charge alone, they should charge with the assistance of an adult. 3.
Notice: 1. When the remote control is turned on, the throttle hold switch is in the ON state, and the remote control beeps . The switch should be turned back to the OFF position. 2. When the remote control is turned on, the 3D switch is in the ON state, and the remote control will beep. The switch should be turned back to the OFF position. 3. When the remote control is turned on, the throttle stick is not in the lowest position, and the remote control will beep.
ABOUT REMOTE CONTROLLER FLIGHT BATTERY INSTALLMENT 1. 2. 3. 4. Put the throttle joystick to the bottom position. Turn on the transmitter. Install the battery into the rack and connect it properly with the receiving power. Once the battery is connected, the signal starts to blink. Keep it still and wait until the signal light stops blinking, which means the receiver has completed self-inspection and gets ready for flight. TROUBLESHOOTING Problem Re-pair (Refer to P.
Problem Cause Solution 5 Turn on the helicopter after binding successfully, the propeller rotate constantly but the helicopter can not take off. 6 Helicopter vibrates or shakes in flight. Damaged frotor blades and lateral axis blade grips too tight causing the movement of the main rotor isn't smooth. Change the main rotor blades, and lateral axis Loosen the blade grips properly. 7 Main rotor blades are shaking in flying. Lateral axis is bent Latreral axis screw is not tight .
ACCESSORIES LIST ACCESSORY LIST NO.
